Included in this .zip file are a few different programs:


1) WRTJTAG.exe (and io.dll) - v.99 beta - This is the newest version of the 
   Debrick Utility.  It is a Windows GUI based version supporting all flash
   chips used/included in the Linksys routers.
2) WRTCFE.exe - v1.0 - This is a quick CFE.BIN modding utility for cooking up 
   a CFE Bootloader with your own MAC Address in case recovery is needed.  It 
   will also allow you to modify the "default" parameters set normally after 
   resetting the unit to factory defaults.
3) WRT54G - v3.0 - (In the Linux directory) - this is the Linux version of the 
   Debrick utility included just for good measure.  This version has not yet 
   been retro-fitted to support all the flash chips that are now supported in 
   the new Windows Version.
4) Docs and .PNG Image - these are the original docs I put together describing
   how to make a JTAG cable and use the original Linux base debricking software.
   This is included only for completeness.


*******************************************************************************************************

This Windows GUI version of the EJTAG Debrick Uility uses the following (since I didn't want to spend
a couple hours writing and debugging a parallel port driver for windows):

    IO.DLL (c) 1995-2003 Fred Bulback
    The documentation for IO.DLL can be found at:   http://www.geekhideout.com/iodll.shtml

Kudos to Fred!

    Note:  Since the IO.DLL is supposed to work under all flavors of Windows then this utility
    should as well; however, I have only personally used it under the XP Pro operating system.

*******************************************************************************************************


Cheers
-hairydairymaid